IsoCoppo Tek - Tile shaped insulated panel
Isocoppo Tek is not a simple insulated metal sheet but an integrated roofing system, with a complete range of accessories, which satisfies any planning or architectural requirement. Outside Isocoppo Tek keeps its tile shape, while an insulated polyurethane foam is introduced inside by injection process.Isocoppo is an insulated sheet, lends itself to many uses and has no limitation.
It is ideal for civil roofing, in particular in areas of architectural interest, for structures and service buildings, such as schools, gymnasiums and social centres.
Lateral overlapping of half a corrugation
Fixing on wood
civil and industrial buldings and for old roof renewal
high load bearing
IsoCoppo Tek sheets standard lengths:*
*For quantities bigger than 500 m2 it is possible to value extra standard sheets dimensions.
- Terracota red
- Terracotta red old tile weathered finish
Flat ridge capping
To be used for connecting pitches, both on top and on diagonal. It is applied in sheets overlapping, both on two and non multi-pitches roofing .
Coppo waves remain open.
Development 406 mm, standard length 3150 mm
Ridge capping with serrated profile
It can be used on top of two pitches, it has serrated profile for closing waves but, as it is composed of 2 pieces, it allows a more regular assembly, as it is not necessary that two opposite pitches are perfectly symmetric.
Partial development 406 mm; Total development 812 mm; standard lenght 3150mm
Universal diagonal ridge capping
To be used for connecting pitches, both on top and on diagonal.· It is composed by a central part and two micro corrugated bendings of special material., which allows a manual arrangement to every corrugation shape, with every pitches or angulations.
Ridge ventilated cap with serrated profile
Serration allows waves corrugation closure; it can be used only on two symmetric pitches.
With micro drilling for a correct ventilation.
Wall ridge upstand
Connection element between vertical wall and roofing pitch. Ridge capping has available ventilation exit mouths and connection bending with sheet Coppo profiled.
Thermo-drilling element in transparent compact polycarbonate.
Maximum dimensions 1340x 1050
Skylight dome and base
Crossing element for roofing inspection or as lighting of an underneath space.
One-piece with manual or electric opening.
On request it is available with double frame as smokes evacuator.
Element in stainless steel prepainted Coppo Red, thickness 1.0 mm.
Flat part dimensions 420 mm x 380 mm
Venduct vent + vent base
Element in PVC with joint and water connection.
Max temperature 60°C.
Fluenta vent + vent base
Element in PVC with water connection.
Upper part open.
Max temperature 60°C.
Antenna cap + vent base
Elements in PVC for cables passage.
Eaves foam filler
Application under the sheet
Element in polyethylene with transverse section like the sheet profile
Available in:aluminium, copper, specific for ventilated roof
Breather membrane "AluPermo"
It is a particular breather, synthetic and watwerproof membrane. The inner vapour pass through while other agents (as rain, damp etc.) stop out. It is particularly suitable for ventilated roof, as protection of isolated layer. Coil highness cm 150 (coil m 70).
Gutter expansion joint “Semmler”
Element to compensate the expansion of materials. It is essential for gutter or valley gutter longer than 20 m
Available in aluminium or prepainted steel
Timber drill screw
With Alubel washer diam. 19 mm
In stainless steel 6,5 x 80 mm
Aluminium 3,4 x 9 mm
Copper 3,4 x 9 mm
Stainless steel 3,4 x 7 mm
Available in 3 width: 50, 75 and 100 mm
For restoration and touch up.