Alutech Dach section

Alutech Dach – Insulated roof sandwich panel

ALUTECH DACH is a composite roofing panel composed of two metal sheet coverings connected by an insulating polyurethane layer . Panels can be installed on any type of bearing structure and in particular on metal structures. Superior sheet corrugation enhances load performances of ALUTECH DACH panels , which can be applied on big support dimensions.



  • Alutech Dach Lateral overlapping of a corrugation

    Lateral overlapping of a corrugation

  • Canale raccolta pannello Alutech Dach

    Detail of drainage channel

    (drainage channel not available for versions in bituminous felt, fiberglass or aluminium foil)
  • Alutech dach Fixing on wood

    Fixing on wood

  • Alutech Dach Fixing on metal stricture

    Fixing on metal



Alutech Dach sandwich panels available thicknesses:

30 mm

40 mm

50 mm

60 mm

80 mm

100 mm

120 mm

Advised use:

roofing

Minimum slope:

10% (this slope depends on the lenght of the panels. Please refer anyway to local regulations)

Sandwich panel technical features:

treadable

insulated

structural

possibility of lateral overlapping

insulation with expanded polyurethane type ‘PUR’ or, upon request and with specific conditions, type ‘PIR’


Alutech Dach versioni

A) prepainted aluminium

B) prepainted aluminium


A) prepainted aluminium

B) ) bituminous felt or centesimal aluminium


A) prepainted galvanised steel

B) prepainted galvanised steel


A) copper

B) prepainted galvanised steel


A) prepainted galvanised steel

B) bituminous felt


C) always with seal


standard colours

  • Simil RAL 9002 White grey
  • Simil RAL 3009 Oxide red
  • Simil RAL 8017 Chocolate brown

Special colours

  • Simil RAL 7016 Anthracite grey
  • Simil RAL 6005 Moss green
  • Simil RAL 9006 Silver

Panel cut arrangement for front overlapping:

Pre-cut on lower panel sheet to facilitate insulation removal


Alutech Dach pre-cut


T = 100, 150, 200, 250, 300 mm
L= min 2500 mm, max 13500 mm
S= 30, 40, 50, 60, 80, 100, 120 mm

Alutech Dach pre-cut


Left overlapping       Right overlapping

Alutech Dach pre-cut



Alutech Dach sandwich panel laying direction

Notched hinged ridge

Development 834 mm

Standard length 3250 mm

  • Notched hinged ridge
  • Notched hinged ridge


Notched pitch/wall connection

Development 500 mm

Length 3250 mm

  • Notched pitch/wall connection
  • Notched pitch/wall connection


Lateral closure

Development 333 mm

Length 3250 mm

  • Lateral closure
  • Lateral closure


Corrugation closing profile

Length 1050 mm

  • corrugation closing profile


Over corrugation seal

Length 1050 mm

  • OVER CORRUGATION SEAL


Polycarbonate sheet

Development 1040 mm

useful length 1000 mm

  • Policarbonate sheet Dach


Skylight base

  • Skylight base Dach

This website use cookies, including those by third parties, to improve our services. By closing this banner, or scrolling down this page or clicking any element, you consent to the use of cookies.